Cisco 1941W Configuration Manual page 47
Cisco 3900 series, cisco 2900 series,
cisco 1900 series
Hide thumbs
Also See for 1941W:
- Hardware installation manual (102 pages) ,
- Installing and upgrading (24 pages)
Table of Contents
Advertisement
Chapter
Configuring Ethernet CFM and Y.1731 Performance Monitoring on Layer 3 Interfaces
DETAILED STEPS
Command
Step 1
enable
Example:
Router>enable
Step 2
configure terminal
Example:
Router#configure terminal
Step 3
ethernet cfm ieee
Example:
Router(config)#ethernet cfm ieee
Step 4
ethernet cfm global
Example:
Router(config)#ethernet cfm global
Step 5
ethernet cfm domain domain-name level
value
Example:
Router(config-ecfm)#ethernet cfm
domain carrier level 2
Step 6
service service-name port
Example:
Router(config-ecfm)#service carrier
port
Step 7
continuity-check interval value
Example:
Router(config-ecfm-srv)#continuity-ch
eck interval 100m
Step 8
end
Example:
Router(config-ecfm-srv)#end
Step 9
configure terminal
Example:
Router#configure terminal
Cisco 3900 Series, Cisco 2900 Series, and Cisco 1900 Series Integrated Services Routers Generation 2 Software Configuration Guide
CFM Support on Routed Port and Port MEP
Purpose
Enables the privileged EXEC mode.
Enter your password when prompted.
Enters the global configuration mode.
Enables the IEEE version of CFM.
Enables CFM processing globally on the router.
Defines a CFM maintenance domain at a specified level,
and enters the Ethernet CFM configuration mode.
level can be any value from 0 to 7.
Creates a service on the interface and sets the
config-ecfm-srv submode.
Enables sending continuity check messages at the set
interval.
Returns the router to the privileged EXEC mode.
Enters the global configuration mode.
39
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
