Cisco 1941W Configuration Manual page 283
Cisco 3900 series, cisco 2900 series,
cisco 1900 series
Hide thumbs
Also See for 1941W:
- Hardware installation manual (102 pages) ,
- Installing and upgrading (24 pages)
Table of Contents
Advertisement
Chapter
Configuring Radio Settings
Randomly selects a different 5-GHz channel.
•
If the channel selected is one of the channels in
•
60 seconds.
If there are no radar signals on the new channel, enables beacons and accepts client associations.
•
If participating in WDS, sends a DFS notification of its new operating frequency to the active WDS
•
device.
You cannot manually select a channel for DFS-enabled 5-GHz radios in Europe and Singapore. The
Note
access points randomly selects a channel. However, in Japan, you can manually select a channel if a radar
has not been detected on it for the previous 30 minutes. If you attempt to select a channel that is
unavailable due to radar detection, the CLI displays a message stating the channel is unavailable.
The full list of channels that require DFS is shown in
Table 2
Channel
56
60
64
100
104
For autonomous operation, DFS requires random channel selection among the channels listed in
The user interface prevents you from manually configuring these channels. The channels that are not
listed in
Prior to transmitting on any channels listed in
Availability Check (CAC). The CAC is a 60 second scan for the presence of radar signals on the channel.
The following sample messages are displayed on the access point console showing the beginning and
end of the CAC scan:
*Mar 6 07:37:30.423: %DOT11-6-DFS_SCAN_START: DFS: Scanning frequency 5500 MHz for
60 seconds
*Mar 6 07:37:30.385: %DOT11-6-DFS_SCAN_COMPLETE: DFS scan complete on frequency
5500 MHz
When operating on any of the DFS channels listed in
access point constantly monitors the channel for radar. If radar is detected, the access point stops
forwarding data packets within 200 ms and broadcasts five beacons that include an 802.11h channel
switch announcement, indicating the channel number that the access point begins using. The following
example message displays on the access point console when radar is detected:
*Mar 6 12:35:09.750: %DOT11-6-DFS_TRIGGERED: DFS: triggered on frequency 5500 MHz
When radar is detected on a channel, that channel may not be used for 30 minutes. The access point
maintains a flag in non-volatile storage for each channel that it detects radar on in the last 30 minutes.
After 30 minutes, the flag is cleared for the corresponding channel. If the access point is rebooted before
a flag is cleared, the non-occupancy time is reset to 30 minutes when the channel initializes.
Cisco 3900 Series, Cisco 2900 Series, and Cisco 1900 Series Integrated Services Routers Generation 2 Software Configuration Guide
DFS Channel List
Frequency
5280 MHz
5300 MHz
5320 MHz
5500 MHz
5500 MHz
Table 2
do not require random selection and may be manually configured.
Table
2, scans the new channel for radar signals for
Table
2.
Channel
Frequency
108
5520 MHz
112
5560 MHz
116
5580 MHz
120
5600 MHz
124
5620 MHz
Table
2, the access point radio performs a Channel
Table
2, in addition to performing the CAC, the
Configuring Radio Channel Settings
Channel
Frequency
128
5640 MHz
132
5660 MHz
136
5680 MHz
140
5700 MHz
—
—
Table
2.
275
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
