Cisco 1941W Configuration Manual page 123
Cisco 3900 series, cisco 2900 series,
cisco 1900 series
Hide thumbs
Also See for 1941W:
- Hardware installation manual (102 pages) ,
- Installing and upgrading (24 pages)
Table of Contents
Advertisement
Chapter
Configuring Backup Data Lines and Remote Management
dialer watch-list 1 ip 64.161.31.254 255.255.255.255
dialer watch-list 1 ip 64.174.91.254 255.255.255.255
dialer watch-list 1 ip 64.125.91.254 255.255.255.255
!
! Dial backup will kick in if primary link is not available
! 5 minutes after CPE starts up.
dialer watch-list 1 delay route-check initial 300
dialer-list 1 protocol ip permit
!
! Direct traffic to an interface only if the dialer is assigned an IP address.
route-map main permit 10
match ip address 101
match interface Dialer1
!
route-map secondary permit 10
match ip address 103
match interface Dialer3
!
! Change console to aux function.
line con 0
exec-timedout 0 0
modem enable
stopbits 1
line aux 0
exec-timeout 0 0
! To enable and communicate with the external modem properly.
script dialer Dialout
modem InOut
modem autoconfigure discovery
transport input all
stopbits 1
speed 115200
flowcontrol hardware
line vty 0 4
exec-timeout 0 0
password cisco
login
!
scheduler max-task-time 5000
end
Starting from Cisco IOS Release 15.3(3)M, if the second core of the CPU was disabled, then you do not
need to include transport input all command in line 2. If the second core was enabled, then the
transport input all command is added to the configuration.
line 2
no activation-character
no exec
transport preferred none
Cisco 3900 Series, Cisco 2900 Series, and Cisco 1900 Series Integrated Services Routers Generation 2 Software Configuration Guide
Configuring Dial Backup and Remote Management Through the Console Port or Auxiliary Port
115
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
