Connecting To An Ethernet Network With Local Power - Cisco Aironet 1130AG Hardware Installation Manual
Hide thumbs
Also See for Aironet 1130AG:
- Hardware installation manual (132 pages) ,
- Quick start manual (49 pages) ,
- Datasheet (13 pages)
Table of Contents
Advertisement
Connecting the Ethernet and Power Cables
Connect the other end of the Ethernet cable to one of the following:
Step 7
•
•
Connecting to an Ethernet Network with Local Power
Be careful when handling the access point; the bottom plate might be hot.
Caution
If your access point is connected to in-line power, do not connect the power module to the access point.
Note
Using two power sources on the access point might cause the access point to shut down to protect internal
components and might cause the switch to shut down the port to which the access point is connected. If
your access point shuts down, you must remove all power and reconnect only a single power source.
Follow these steps to connect the access point to an Ethernet LAN when you are using a local power
source:
If necessary, open the access point cover (see the
Step 1
page
Pull the Category 5 Ethernet cable and the power module cable out of the access point cable bay area
Step 2
approximately 1 foot.
Loop the Ethernet cable back towards the access point Ethernet connector (see
Step 3
Connect the Ethernet cable to the RJ-45 Ethernet connector labeled Ethernet on the access point (see
Step 4
Figure
Loop the power cable back towards the access point 48-VDC power port (see
Step 5
of the power port).
Connect the power module output connector to the access point power port.
Step 6
Push or pull the excess cable lengths (both loops) back through the access point cable bay area.
Step 7
Close the access point cover by sliding it over the cable bay area until you hear a click.
Step 8
Plug the other end of the Ethernet cable into an unpowered Ethernet port on your LAN network.
Step 9
Plug the other end of the power module into an approved 100- to 240-VAC outlet.
Step 10
For information on securing your access point, see the
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
2-22
A switch with inline power (see the
page
2-20).
The end of a Cisco Aironet power injector labeled To AP/Bridge. Connect the other end labeled To
Network to your 10/100 Ethernet LAN.
2-9).
2-1).
"Connecting the Ethernet and Power Cables" section on
"Opening the Access Point Cover" section on
"Securing the Access Point" section on page
Chapter 2
Installing the Access Point
Figure
2-15).
Figure 2-1
for the location
OL-6226-02
2-17.
- Quick Links:
- Ethernet Port
- Checking the Access Point Leds
Hide quick links:
Advertisement
Table of Contents
