Dual-Radio Operation; Ethernet Port; Console Port; Leds - Cisco Aironet 1130AG Hardware Installation Manual
Hide thumbs
Also See for Aironet 1130AG:
- Hardware installation manual (132 pages) ,
- Quick start manual (49 pages) ,
- Datasheet (13 pages)
Table of Contents
Advertisement
Chapter 1
Overview
Dual-Radio Operation
The access point supports simultaneous radio operation using a 2.4-GHz 802.11g radio and a 5-GHz
802.11a radio. Each radio uses dual-diversity integrated antennas.
The 5-GHz radio incorporates an Unlicensed National Information Infrastructure (UNII) radio
transceiver operating in the UNII 5-GHz frequency bands. The 802.11g radio is called Radio0 and the
802.11a radio is called Radio1.
Ethernet Port
The auto-sensing Ethernet port accepts an RJ-45 connector, linking the access point to your 10BASE-T
or 100BASE-T Ethernet LAN. The access point can receive power through the Ethernet cable from a
power injector, switch, or power patch panel. The Ethernet MAC address is printed on the label on the
back of the access point (refer to
closed top cover (see
Do not attempt to connect a cable with a protective boot to the access point Ethernet port. Because of
Note
limited space in the connection area, booted connectors will not fit.
Console Port
The serial console port provides access to the access point's command-line interface (CLI) using a
terminal emulator program. The port is located in a cable bay area that is hidden by the top cover (see
Figure
point's serial console port. (Refer to
console port pinouts.) Assign the following port settings to a terminal emulator to open the management
system pages: 9600 baud, 8 data bits, No parity, 1 stop bit, and no flow control.
Do not attempt to connect a cable with a protective boot to the access point console port. Because of
Note
limited space in the connection area, booted connectors will not fit.
LEDs
The access point has three LEDs to indicate Ethernet activity, radio activity, and status indications (refer
to the
•
•
•
The access point cover must be closed to view the Status LED but the cover must be open to view the
Note
Ethernet and the Radio LEDs.
Figure 1-1
OL-6226-02
Figure
1-1).
1-1). Use an RJ-45 to DB-9 serial cable to connect your computer's COM port to the access
"Checking the Access Point LEDs" section on page 6-2
The Status LED provides general operating status and error indications (top cover closed).
The Ethernet LED is located in the cable bay area under the access point top cover. This LED signals
Ethernet traffic on the wired Ethernet LAN and provides Ethernet error indications.
The Radio LED is located in the cable bay area under the access point top cover. This LED signals
that wireless packets are being transmitted or received over the radio interface and provides radio
error indications.
shows the locations of the three LEDs.
Figure
1). The port is located in a cable bay area that is hidden by the
Appendix E, "Console Cable Pinouts,"
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
Hardware Features
for a description of the
for additional information).
1-3
- Quick Links:
- Ethernet Port
- Checking the Access Point Leds
Hide quick links:
Advertisement
Table of Contents
