Manufacturers Federal Communication Commission Declaration Of Conformity Statement - Cisco Aironet 1130AG Hardware Installation Manual
Hide thumbs
Also See for Aironet 1130AG:
- Hardware installation manual (132 pages) ,
- Quick start manual (49 pages) ,
- Datasheet (13 pages)
Table of Contents
Advertisement
Manufacturers Federal Communication Commission Declaration of Conformity Statement
Manufacturers Federal Communication Commission
Declaration of Conformity Statement
FOR HOME OR OFFICE USE
Model:
FCC Certification number:
Manufacturer:
This device complies with Part 15 rules. Operation is subject to the following two conditions:
1.
2.
This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a residential environment. This equipment generates,
uses, and radiates radio frequency energy, and if not installed and used in accordance with the
instructions, may cause harmful interference. However, there is no guarantee that interference will not
occur. If this equipment does cause interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to correct the interference by one of the
following measures:
•
•
•
•
The Part 15 radio device operates on a non-interference basis with other devices operating at this
Caution
frequency when using the integrated antennas. Any changes or modification to the product not expressly
approved by Cisco could void the user's authority to operate this device.
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
B-2
Tested To Comply
With FCC Standards
AIR-AP1131AG-A-K9
LDK102054
Cisco Systems, Inc.
170 West Tasman Drive
San Jose, CA 95134-1706
USA
This device may not cause harmful interference, and
This device must accept any interference received, including interference that may cause undesired
operation.
Reorient or relocate the receiving antenna.
Increase separation between the equipment and receiver.
Connect the equipment to an outlet on a circuit different from which the receiver is connected.
Consult the dealer or an experienced radio/TV technician.
Appendix B
Declarations of Conformity and Regulatory Information
OL-6226-02
- Quick Links:
- Ethernet Port
- Checking the Access Point Leds
Hide quick links:
Advertisement
Table of Contents
