Connecting To An Ethernet Network With An Inline Power Source; Connecting To An Ethernet Network With Local Power - Cisco Aironet AIR-AP1200 Hardware Installation Manual
Aironet 1200 series access point
Hide thumbs
Also See for Aironet AIR-AP1200:
- Hardware installation manual (138 pages) ,
- User manual (36 pages) ,
- Ordering manual (6 pages)
Table of Contents
Advertisement
Chapter 2
Installing the Access Point
Connecting to an Ethernet Network with an Inline Power Source
Caution
The Cisco Aironet Power Injectors are designed for use with Cisco Aironet access points only. Using the
power injector with other Ethernet-ready devices can damage the equipment.
Only the fiber-optic power injector (AIR-PWRINJ-FIB) has been tested to UL 2043 for operation in a
Caution
building's environmental air space; no other power injectors or power modules have been tested to UL 2043
and they should not be placed in a building's environmental air space, such as above suspended ceilings.
Follow these steps to connect the access point to the Ethernet LAN when you have an inline power
source:
Step 1
Connect the Ethernet cable to the RJ-45 Ethernet connector labeled Ethernet on the access point.
Step 2
Connect the other end of the Ethernet cable to one of the following:
•
•
•
If you use a power supply or power injector to power the access point, you must use the power supply
Note
included with your access point and the Cisco Aironet Power Injector for the 1100 and 1200 series access
points.
Connecting to an Ethernet Network with Local Power
Follow these steps to connect the access point to an Ethernet LAN when you are using a local power
source:
Connect the Ethernet cable to the RJ-45 Ethernet connector labeled Ethernet on the access point.
Step 1
Step 2
Plug the other end of the Ethernet cable into an unpowered Ethernet port on your network.
Connect the power module's output connector to the 48-VDC power port labeled 48VDC on the access
Step 3
point.
Step 4
Plug the other end of the power module into an approved 100- to 240-VAC outlet.
OL-4310-05
A switch with inline power, such as a Cisco Catalyst 3500XL, 3550-24 PWR, 4000, or 6500 switch.
An inline power switch panel, such as a Cisco Catalyst Inline Power Patch Panel.
The end of a Cisco Aironet power injector labeled To AP/Bridge. Connect the other end labeled To
Network to the 10/100 Ethernet LAN.
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
Connecting the Ethernet and Power Cables
2-9
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
