Connecting To An Ethernet Network With An Inline Power Source - Cisco Aironet 1130AG Hardware Installation Manual
Hide thumbs
Also See for Aironet 1130AG:
- Hardware installation manual (132 pages) ,
- Quick start manual (49 pages) ,
- Datasheet (13 pages)
Table of Contents
Advertisement
Chapter 2
Installing the Access Point
Connecting to an Ethernet Network with an Inline Power Source
Caution
Be careful when handling the access point; the bottom plate might be hot.
If your access point is connected to in-line power, do not connect the power module to the access point.
Note
Using two power sources on the access point might cause the access point to shut down to protect internal
components and might cause the switch to shut down the port to which the access point is connected. If
your access point shuts down, you must remove all power and reconnect only a single power source.
Follow these steps to connect the access point to the Ethernet LAN when you have an inline power
source:
If necessary, open the access point cover (see the
Step 1
page
Pull the Category 5 Ethernet cable out of the access point cable bay area approximately 1 foot.
Step 2
Loop the cable back towards the Ethernet connector (see
Step 3
Figure 2-15
Step 4
Connect the Ethernet cable to the RJ-45 Ethernet connector labeled Ethernet on the access point.
Step 5
Push or pull the excess cable length (the loop) back through the access point cable bay area.
Close the access point cover by sliding it over the cable bay area until you hear a click.
Step 6
OL-6226-02
2-9).
Looping the Ethernet Cable
"Opening the Access Point Cover" section on
Figure
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
Connecting the Ethernet and Power Cables
2-15)
2-21
- Quick Links:
- Ethernet Port
- Checking the Access Point Leds
Hide quick links:
Advertisement
Table of Contents
