Overview
Overview
The access point requires a special serial cable that connects the access point serial console port (RJ-45
connector) to your PC's COM port (DB-9 connector). This cable can be purchased from Cisco or can be
built using the pinouts in this appendix.
The Cisco part number for the DB-9 to RJ-45 serial cable is AIR-CONCAB1200. Browse to
Note
http://www.cisco.com/en/US/ordering/index.shtml
Console Port Signals and Pinouts
Use the console RJ-45 to DB-9 serial cable to connect the access point's console port to the COM port
of your PC running a terminal emulation program.
Both the Ethernet and console ports use RJ-45 connectors. Be careful to avoid accidently connecting the
Note
serial cable to the Ethernet port connector.
After completing your configuration changes, you must remove the serial console cable from the access
Note
point.
Table E-1
Table E-1
Console Port
RJ-45
Pins
1
2
3
4
5
6
7
8
1. NC indicates not connected.
2. TXD indicates transmit data.
3. RXD indicates receive data.
4. GND indicates ground
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
E-2
lists the signals and pinouts for the console RJ-45 to DB-9 serial cable.
Signals and Pinouts for a Console RJ-45 to DB-9 Serial Cable
PC COM Port
DB-9
Signals
Pins Signals
1
NC
–
–
1
NC
–
–
2
TXD
2
RXD
4
GND
5
GND
3
GND
5
GND
5
RXD
3
TXD
1
NC
–
–
1
NC
–
–
to order a serial cable.
3
4
4
2
Appendix E
Console Cable Pinouts
OL-6226-02