Figure 8-43. Control Top Bezel Assembly; Radio Reassembly - Motorola APX 5000 Service Manual
Hide thumbs
Also See for APX 5000:
- Service manual (438 pages) ,
- Quick reference card (2 pages) ,
- User manual (45 pages)
Table of Contents
Advertisement
Sec 2: 8-32
8.9
Radio Reassembly
This section contains instructions for reassembling the radio.
8.9.1
Reassemble the Main Sub Assemblies
8.9.1.1 Assemble Control Top Assembly (F) to Main Chassis Assembly (E)
.
Control Top Screws (57)
1. Verify there are no surface irregularities such as scratches or indentations on both the Control
Top Main Seal Grove and the Seal's mating surface on the Main Chassis Assembly (15). Also
ensure that the Control Top Main Seal (22) and surrounding surfaces are free of debris and
other foreign material.
2. Verify Control Top Main Seal is properly seated into its groove and place Control Top
Assembly onto Main Chassis Assembly as shown in
3. Torque both screws with a Torx IP8 Bit and a torque Driver to 7 in-lbs.
4. Place Antenna Washer (26) over the antenna nut then torque Antenna Spanner Nut (27) with
the Antenna Spanner Bit to 16 in-lbs.
8.9.1.2 Assemble Knobs (G)
Figure 8-43. Control Top Bezel Assembly
Frequency Knob (56)
Figure 8-44. Knobs Assembly
Disassembly/Reassembly Procedures: Radio Reassembly
Antenna Nut and Washer (26
Control Top Assembly (58)
Figure 8-43.
Volume Knob (55)
,
27)
Advertisement
Chapters
Table of Contents
Troubleshooting
