Tray Selection; Out Of Memory Message - Brother MFC-9840CDW User Manual
Hide thumbs
Also See for MFC-9840CDW:
- User manual (263 pages) ,
- Network user's manual (204 pages) ,
- Quick setup manual (53 pages)
Table of Contents
Advertisement
Tray selection
You can change the tray use only for the next
copy.
a
Make sure you are in Copy mode
b
Load your document.
c
Use the dial pad to enter the number of
copies (up to 99).
d
Press Tray Select.
e
Press d or c to choose the MP>T1,
T1>MP, #1(XXX)
Press OK.
f
Press Mono Start or Colour Start.
Press Tray Select
1
XXX is the paper size you set in Menu, 1, 3.
Note
• T2 or #2 appears only if the optional paper
tray is installed.
• To change the default setting for Tray
Select, see Tray use in copy
mode on page 23.
12
.
1
1
and MP(XXX)
.
MP>T1 or M>T1>T2
T1>MP or T1>T2>M
1
#1(XXX)
1
#2(XXX)
1
MP(XXX)
Out of memory
message
If the memory becomes full while you are
making copies, the LCD message will guide
you through the next step.
If you get an Out of Memory message
while scanning a subsequent page, you will
have the option to press Mono Start or
Colour Start to copy the pages scanned so
far, or to press Stop/Exit to cancel the
operation.
To make extra memory available, you can do
the following:
Print the faxes that are in the memory.
(See Printing a fax from the
memory on page 49.)
Turn off Fax Storage. (See Turning off
remote fax options on page 67.)
Add optional memory. (See Memory
board on page 110.)
Note
When you get an Out of Memory
message, you may be able to make
copies if you first print incoming faxes in
the memory to restore the memory to
100%.
Making copies
12
12
85
Advertisement
Table of Contents
