Networkport Settings; Networkport [2] Mode - Cisco TelePresence System Codec C40 Administrator's Manual
Hide thumbs
Also See for TelePresence System Codec C40:
- Reference manual (224 pages) ,
- Administrator's manual (151 pages) ,
- User manual (51 pages)
Table of Contents
Advertisement
Cisco TelePresence System Codec C40/C60 and Profiles using C40/60
Contents
NetworkPort settings
NetworkPort [2] Mode
Define if the network port 2 shall be enabled for direct pairing with a Cisco TelePresence Touch
controller.
NOTE: Restart the system for any change to this setting to take effect.
Requires user role: ADMIN
Value space: <Inactive/DirectPairing>
Inactive: Set the NetworkPort 2 to Inactive when no device is connected.
DirectPairing: Set the NetworkPort 2 to DirectPairing when you have a Cisco TelePresence
Touch controller connected to the port. This will enable for direct pairing between the Touch
controller and the codec.
NetworkPort 2 Mode: Inactive
Example:
D14636.10
Profile C60-C40 and Codec C60-C40
Introduction
Web interface
Administrator Guide TC6.1, APRIL 2013.
System settings
System settings
www.cisco.com — Copyright © 2010-2013 Cisco Systems, Inc. All rights reserved.
81
Administrator Guide
Setting passwords
Appendices
- Quick Links:
- Codec C40 at a Glance
- Factory Reset
Hide quick links:
Advertisement
Chapters
Table of Contents
