Configuring Mpls-Tp Lsps At Midpoint - Cisco ASR 9000 Series Configuration Manual
Aggregation services router mpls
Hide thumbs
Also See for ASR 9000 Series:
- Command reference manual (1138 pages) ,
- Routing configuration manual (702 pages) ,
- Reference manual (696 pages)
Table of Contents
Advertisement
Implementing MPLS Transport Profile
Command or Action
Step 12
protect-lsp
Example:
RP/0/RSP0/CPU0:router(config-if)# protect-lsp
Step 13
in-label num
Example:
RP/0/RSP0/CPU0:router(config-if-protect)#
in-label 113
Step 14
out-label mpls label out-link link ID
Example:
RP/0/RSP0/CPU0:router(config-if-protect)#
out-label 112 out-link 2
Step 15
lsp-number value
Example:
RP/0/RSP0/CPU0:router(config-if-protect)#
lsp-number 10
Step 16
exit
Example:
RP/0/RSP0/CPU0:router(config-if-protect)# exit
Step 17
Use the commit or end command.
Configuring MPLS-TP LSPs at Midpoint
Perform this task to configure the MPLS-TP LSPs at the midpoint router.
OL-28381-02
Cisco ASR 9000 Series Aggregation Services Router MPLS Configuration Guide, Release 4.3.x
Configuring MPLS-TP LSPs at Midpoint
Purpose
Specifies a backup for a working LSP. If the working
LSP fails, traffic is switched to the protect LSP until the
working LSP is restored, at which time traffic forwarding
reverts back to the working LSP.
Specifies the in-label.
Specifies the out-label and out-link.
Specifies the LSP ID of the protect LSP.
Exits from protect LSP interface configuration mode.
commit—Saves the configuration changes and remains
within the configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without
committing the configuration changes.
• Cancel—Remains in the configuration mode,
without committing the configuration changes.
325
Advertisement
Table of Contents
