Reboot The Access Point - Cisco Aironet 1550 Series Hardware Installation Manual
Outdoor mesh access point
Hide thumbs
Also See for Aironet 1550 Series:
- Deployment manual (276 pages) ,
- Installation manual (164 pages) ,
- Getting started manual (59 pages)
Table of Contents
Advertisement
Chapter 2
Installing the Access Point
Figure 2-27
1
Figure 2-28
1
Reboot the Access Point
To reboot (power cycle) the access point, follow these steps:
Use a Phillips screwdriver to remove the reset button screw
Step 1
screw.
Use a straightened paperclip, and push the reset button for less than 10 seconds. This action causes the
Step 2
access point to reboot (power cycle), all LEDs to turn off for approximately 5 seconds, and then the
LEDs to reactivate.
Replace the reset button screw and use a Phillips screwdriver to tighten to 22 to 24 in. lbs
Step 3
(2.49 to 2.71 Nm).
OL-24247-01
Reset Button Location - Models AIR-CAP1552E-x-K9 and AIR-CAP1552H-x-K9
4
Reset button
Reset Button Location - Models AIR-CAP1552C-x-K9 and AIR-CAP1552I-x-K9
1
Reset button
Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide
5
6
(Figure
2-27). Be careful not to lose the
Installing the Access Point
1
2-39
- Quick Links:
- Using the Reset Button
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
