Table of Contents
Advertisement
4.1 Overview
Before You Begin
Take note of the following points before starting work. Always remove the AC adapter and
battery pack before commencing any of the procedures. The procedure for removing the
battery pack is described in section "4.2. Battery Pack".
Do not disassemble the computer unless it is operating abnormally.
Use the designated tools.
Ensure that the environment for working on and storing parts does not contain any of the
following.
•
Dust or dirt
•
Static electricity
•
Extremely hot, cold, or humid conditions
Perform the diagnostic tests described in Chapter 2 to determine which FRU is the cause of
the fault.
Do not perform any unnecessary work. Always work in accordance with the disassembly and
re-assembly procedures in this manual.
Keep parts removed from the computer in a safe place away from the computer where they
will not be damaged or interfere with your work.
Disassembling requires the removal of a large number of screws. Keep removed screws in a
safe place such that you can determine which screws belong to which part.
When re-assembling, ensure that you use the correct screws and fit parts in the correct
position. Screw sizes are noted in the text and figures.
As all parts have sharp edges and corners, take care not to cut yourself.
After replacing an FRU, check that the computer and replaced part operate correctly.
Satellite R20/TECRA M7 Maintenance Manual (960-572)
4 Replacement Procedures
[CONFIDENTIAL]
4-3
Advertisement
Chapters
Table of Contents
Troubleshooting
