Table of Contents
Advertisement
4 Replacement Procedures
4.6
MDC/USIM card
Removing the MDC/USIM card
The following describes the procedure for removing the MDC/USIM card. (See Figure 4-6
and 4-7.)
1. Loosen the screw (with e-ring) and remove the MDC/USIM card cover.
2. Remove the following screws securing the USIM card and MDC.
• M2×8B
• M2×4B
3. Disconnect the USIM card cable from the connector CN9520 on the system board
and remove the USIM card.
4. Disconnect the USIM card cable from the connector on the USIM card.
M2×8B BIND or M2×4B BIND
USIM card cable
4-14
[CONFIDENTIAL]
BIND screw
or
BIND screw
CN9520
Figure 4-6 Removing the USIM card
Satellite R20/TECRA M7 Maintenance Manual (960-572)
4.6 MDC/USIM card
×2 (For models with USIM card)
×2 (For models without USIM card)
Screw (e-ring)
MDC/USIM card cover
M2×8B BIND or M2×4B BIND
USIM card
Advertisement
Chapters
Table of Contents
Troubleshooting
