Table of Contents
Advertisement
Appendix F
Cisco Unified IP Phone Non-Lockable Wall Mount
•
•
•
•
•
Before You Begin
You need these tools to install the bracket:
•
•
•
You must also install an Ethernet jack for the telephone in the desired location if an Ethernet jack does
not currently exist. This jack must be wired appropriately for an Ethernet connection. You cannot use a
regular telephone jack. For more information about phone installation requirements and warnings, see
Setting Up the Cisco Unified IP Phone, page
Install Non-Lockable Wall Mount Kit for Phone
Mount the wall bracket in the desired location. You can install the bracket over an Ethernet jack, or you
Step 1
can run the Ethernet network cable to a jack nearby.
a.
b.
c.
d.
e.
The following figure shows the steps to mount the wall bracket.
Cisco Unified IP Phone 6901 and 6911 Administration Guide for Cisco Unified Communications Manager 8.6 (SCCP and SIP)
OL-24582-01
One phone bracket
One wall bracket
Four #8-18 x 1.25-inch Phillips-head screws with four anchors
Two M2.5 x 6 mm machine screws
One 6-inch Ethernet cable
#1 and #2 Phillips-head screwdrivers
Level
Pencil
Hold the bracket on the wall, placing it so that the arrow on the back of the bracket is pointing up.
Use the level to ensure the bracket is level and use a pencil to mark the screw holes.
Use a #2 Phillips-head screwdriver to carefully center the anchor over the pencil mark and press the
anchor into the wall.
Screw the anchor clockwise into the wall until it is seated flush.
Use the included screws and a #2 Phillips-head screwdriver to attach the bracket to the wall.
ADA Non-Lockable Wall Mount Kit for 6900 Series
3-1.
F-3
- Quick Links:
- Performing a Factory Reset
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
