hit counter script

Cisco SF200-24 Administration Manual page 216

Small business 200 series smart switch
Hide thumbs Also See for SF200-24:
Table of Contents

Advertisement

Configuring Multicast Forwarding
Querying IGMP/MLD IP Multicast Group
STEP 5
Querying IGMP/MLD IP Multicast Group
STEP 1
STEP 2
STEP 3
Cisco Small Business 200 1. 1 Series Smart Switch Administration Guide
Last Member Query Counter—Enter the Last Member Query Count to be
used if the switch cannot derive the value from the messages sent by the
elected querier.
Operational Last Member Query Counter—Displays the operational value
of the Last Member Query Counter.
Last Member Query Interval—Enter the Maximum Response Delay to be
used if the switch cannot read Max Response Time value from Group-
Specific queries sent by the elected querier.
Operational Last Member Query Interval—The Last Member Query
Interval sent by the elected querier.
Immediate Leave—When enabled, reduces the time it takes to block
unnecessary MLD traffic sent to a switch port.
Click Apply. The Running Configuration file is updated.
IGMP/MLD IP Multicast Group
The
learned from IGMP/MLD messages.
There might be a difference between information on this page and, for example,
information displayed in the
is in MAC-based groups and a port that requested to join the following Multicast
groups 224. 1 . 1 . 1 and 225. 1 . 1 . 1 , both are mapped to the same MAC Multicast
address 01:00:5e:01:01:01. In this case, there is a single entry in the
page, but two entries on this page.
To query for a IP Multicast group:
Click Multicast > IGMP/MLD IP Multicast Group. The IGMP/MLD IP Multicast
Group page opens.
Set the type of snooping group for which to search: IGMP or MLD.
Enter some or all of following query filter criteria:
Group Address equals to—Defines the Multicast group MAC address or IP
address to query.
page displays the IPv4 and IPv6 group address
MAC Group Address
page
.
Assuming that the system
MAC Multicast
15
207

Advertisement

Table of Contents
loading

Table of Contents