Setting Remote Logging Settings - Cisco SF200-24 Administration Manual
Small business 200 series smart switch
Hide thumbs
Also See for SF200-24:
- Quick start manual (57 pages) ,
- Administration manual (337 pages) ,
- Datasheet (11 pages)
Table of Contents
Advertisement
Managing System Logs
Setting Remote Logging Settings
STEP 3
Setting Remote Logging Settings
STEP 1
STEP 2
STEP 3
Cisco Small Business 200 1. 1 Series Smart Switch Administration Guide
•
RAM Memory Logging—Select the severity levels of the messages to be
logged to RAM.
•
Flash Memory Logging—Select the severity levels of the messages to be
logged to Flash memory.
Click Apply. The Running Configuration file is updated.
Remote Log Servers
The
log messages are sent (using the SYSLOG protocol). For each server, you can
configure the severity of the messages that it receives.
To define SYSLOG servers:
Click Administration > System Log > Remote Log Servers. The
Servers
page opens.
This page displays the list of remote log servers.
Add Remote Log Server
Click Add. The
Enter the parameters.
•
Server Definition—Select whether to specify the remote log server by IP
address or name.
•
IP Version—Select the supported IP format.
•
IPv6 Address Type—Select the IPv6 address type (if IPv6 is used). The
options are:
-
Link Local—The IPv6 address uniquely identifies hosts on a single
network link. A link local address has a prefix of FE80, is not routable, and
can be used for communication only on the local network. Only one link
local address is supported. If a link local address exists on the interface,
this entry replaces the address in the configuration.
-
Global—The IPv6 address is a global Unicast IPV6 type that is visible and
reachable from other networks.
•
Link Local Interface—Select the link local interface (if IPv6 Address Type
Link Local is selected) from the list.
page enables defining remote SYSLOG servers where
page opens.
3
Remote Log
18
Hide quick links:
Advertisement
Table of Contents
