Common Smartport Tasks - Cisco SF200-24 Administration Manual
Small business 200 series smart switch
Hide thumbs
Also See for SF200-24:
- Quick start manual (57 pages) ,
- Administration manual (337 pages) ,
- Datasheet (11 pages)
Table of Contents
Advertisement
Smartports
Common Smartport Tasks
Common Smartport Tasks
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
STEP 8
STEP 9
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
Cisco Small Business 200 1. 1 Series Smart Switch Administration Guide
This section describes some common tasks to setup Smartport and Auto
Smartport.
Workflow1:
To globally enable Auto Smartport on the switch, and to
configure a port with Auto Smartport, perform the following steps:
To enable the Auto Smartport feature on the switch, open the Smartport >
Properties page. Set Administrative Auto Smartport to Enable or Enable by Voice
VLAN.
Select whether the switch is to process CDP and/or LLDP advertisements from
connected devices.
Select which type of devices will be detected in the Auto Smartport Device
Detection field.
Click Apply
To enable the Auto Smartport feature on one or more interfaces, open the
Smartport > Interface Settings page.
Select the interface, and click Edit.
Select Auto Smartport in the Smartport Application field.
Check or uncheck Persistent Status if desired.
Click Apply.
Workflow2:
To configure an interface as a static Smartport, perform the
following steps:
To enable the Smartport feature on the interface, open the Smartport > Interface
Settings page.
Select the interface, and click Edit.
Select the Smartport type that is to be assigned to the interface in the Smartport
Application field.
Set the macro parameters as required.
Click Apply.
9
114
Hide quick links:
Advertisement
Table of Contents
