Installing the HDD
To install the HDD, follow the steps below and refer to Figure 4-4 to 4-6.
CAUTION: Do not hold the HDD by its top and bottom flat surfaces. It may damage the
HDD.
1. Seat the HDD in the HDD bracket and secure the following screws.
• M3×4L
2. Put the HDD into its slot and connect the HDD to the connector.
3. Secure them with the following screws.
• M2×3L
CAUTION: Do not apply pressure to the center of the HDD pack. It may damage the
HDD pack. Hold the HDD pack by its corners.
4.
Set the HDD cover and secure it with the screw (with an e-ring).
Satellite/Satellite Pro U500/U500D, PORTEGE M900/M900D
FLAT HEAD screw
FLAT HEAD screw
4 Replacement Procedures
×4
×4
Maintenance Manual 4-21