User Exec Mode - Cisco Catalyst 3030 Command Reference Manual
Blade switch
Hide thumbs
Also See for Catalyst 3030:
- Getting started manual (34 pages) ,
- Getting started (122 pages)
Table of Contents
Advertisement
CLI Command Modes
Table 1-1
and how to exit that mode. The prompts listed use the default name Switch.
Table 1-1
Command Modes Summary
Command Mode
Access Method
User EXEC
This is the first level of access.
(For the switch) Change terminal
settings, perform basic tasks, and
list system information.
Privileged EXEC
From user EXEC mode, enter the
enable command.
Global
From privileged EXEC mode,
configuration
enter the configure command.
Interface
From global configuration mode,
configuration
specify an interface by entering
the interface command followed
by an interface identification.
Config-vlan
In global configuration mode,
enter the vlan vlan-id command.
VLAN
From privileged EXEC mode,
configuration
enter the vlan database
command.
Line configuration
From global configuration mode,
specify a line by entering the line
command.
User EXEC Mode
After you access the device, you are automatically in user EXEC command mode. The EXEC commands
available at the user level are a subset of those available at the privileged level. In general, use the user
EXEC commands to temporarily change terminal settings, perform basic tests, and list system
information.
Cisco Catalyst Blade Switch 3030 Command Reference
1-2
lists the main command modes, how to access each mode, the prompt you see in that mode,
Prompt
Switch>
Switch#
Switch(config)#
Switch(config-if)#
Switch(config-vlan)#
Switch(vlan)#
Switch(config-line)#
Chapter 1
Using the Command-Line Interface
Exit or Access Next Mode
Enter the logout command.
To enter privileged EXEC mode, enter
the enable command.
To exit to user EXEC mode, enter the
disable command.
To enter global configuration mode,
enter the configure command.
To exit to privileged EXEC mode,
enter the exit or end command, or
press Ctrl-Z.
To enter interface configuration mode,
enter the interface configuration
command.
To exit to privileged EXEC mode,
enter the end command, or press
Ctrl-Z.
To exit to global configuration mode,
enter the exit command.
To exit to global configuration mode,
enter the exit command.
To return to privileged EXEC mode,
enter the end command, or press
Ctrl-Z.
To exit to privileged EXEC mode,
enter the exit command.
To exit to global configuration mode,
enter the exit command.
To return to privileged EXEC mode,
enter the end command, or press
Ctrl-Z.
78-17262-01
Advertisement
Table of Contents
