Checking Wiring And Connectors; Exhaust Leakage; Water Leakage; Engine Oil Leakage - Yamaha F75 Owner's Manual
Outboard motor
Hide thumbs
Also See for F75:
- Owner's manual (234 pages) ,
- Installation manual (224 pages) ,
- Maintenance manual (36 pages)
Table of Contents
Advertisement
Maintenance
1
1. Oil filler cap
5.
Start the engine and watch to make sure
the low oil pressure warning indicator (if
equipped) turns off. Make sure that there
are no oil leaks.
ECM00680
CAUTION:
If the low oil pressure warning indicator
does not turn off or if there are oil leaks,
stop the engine and find the cause. Con-
tinued operation with a problem could
cause severe engine damage. Consult
your Yamaha dealer if the problem cannot
be located and corrected.
6.
Turn off the engine and wait 3 minutes.
Recheck the oil level using the dipstick to
be sure the level falls between the upper
and lower marks. Fill with oil if it is below
the lower mark, or drain to the specified
level if it is above the upper mark.
1. Lower level mark
53
2. Oil dipstick
3. Upper level mark
7.
Dispose of used oil according to local
regulations.
NOTE:
For more information on the disposal of
G
used oil, consult your Yamaha dealer.
Change the oil more often when operating
G
ZMU04271
the engine under adverse conditions such
as extended trolling.
EMU29112
Checking wiring and connectors
Check that each grounding wire is properly
G
secured.
Check that each connector is engaged se-
G
curely.
EMU29120
Exhaust leakage
Start the engine and check that no exhaust
leaks from the joints between the exhaust
cover, cylinder head, and body cylinder.
EMU29130
Water leakage
Start the engine and check that no water
leaks from the joints between the exhaust
cover, cylinder head, and body cylinder.
EMU29140
Engine oil leakage
Check for oil leaks on the around the engine.
ZMU04243
Advertisement
Table of Contents
