Warming Up Engine; Manual Start And Electric Start Models - Yamaha F75 Owner's Manual
Outboard motor
Hide thumbs
Also See for F75:
- Owner's manual (234 pages) ,
- Installation manual (224 pages) ,
- Maintenance manual (36 pages)
Table of Contents
Advertisement
Operation
4.
Turn the main switch to "
and hold it for a maximum of 5 seconds.
OFF
5.
Immediately after the engine starts, re-
lease the main switch to return it to "
(on).
ECM00191
CAUTION:
Never turn the main switch to "
G
(start) while the engine is running.
Do not keep the starter motor turning for
G
more than 5 seconds. If the starter motor
is turned continuously for more than 5
seconds, the battery will be quickly dis-
charged, thus making it impossible to
start the engine. The starter can also be
damaged. If the engine will not start after
5 seconds of cranking, return the main
switch to "
" (on), wait 10 seconds,
then crank the engine again.
31
" (start),
ON
START
ZMU01881
EMU27670
Warming up engine
EMU30030
Manual start and electric start models
1.
After starting the engine, allow it to idle for
3 minutes to warm up. Failure to do so will
shorten engine life.
2.
Be sure the low oil pressure warning indi-
cator goes off after starting the engine.
3.
Check for a steady flow of water from the
cooling water pilot hole.
ECM01340
CAUTION:
If the low oil pressure warning indicator
G
does not go off after the engine starts,
stop the engine. Otherwise serious en-
gine damage could occur. Check the oil
level and add oil if necessary. Consult
your Yamaha dealer if the cause for the
low oil pressure warning indicator can-
not be found.
A continuous flow of water from the pilot
G
hole shows that the water pump is
pumping water through the cooling pas-
sages. If water is not flowing out of the
"
pilot hole at all times while the engine is
running, overheating and serious dam-
age could occur. Stop the engine and
check whether the cooling water inlet on
"
the lower case or the cooling water pilot
hole is blocked. Consult your Yamaha
dealer if the problem cannot be located
and corrected.
If the cooling passage is frozen, it may
G
take awhile for water to start flowing out
of the pilot hole.
Advertisement
Table of Contents
