Engine Stop Button; Main Switch; Power Trim And Tilt Switch On Remote Control Or Tiller Handle - Yamaha F75 Owner's Manual
Outboard motor
Hide thumbs
Also See for F75:
- Owner's manual (234 pages) ,
- Installation manual (224 pages) ,
- Maintenance manual (36 pages)
Table of Contents
Advertisement
1. Lanyard
2. Lock plate
EMU26001
Engine stop button
To open the ignition circuit and stop the en-
gine, push this button.
EMU26090
Main switch
The main switch controls the ignition system;
its operation is described below.
"
" (off)
G
With the main switch in the "
tion, the electrical circuits are off, and the key
can be removed.
"
" (on)
G
With the main switch in the "
the electrical circuits are on, and the key can-
not be removed.
"
" (start)
G
With the main switch in the "
sition, the starter motor turns to start the en-
gine. When the key is released, it returns
automatically to the "
EMU26141
Power trim and tilt switch on remote
control or tiller handle
The power trim and tilt system adjusts the out-
board motor angle in relation to the transom.
Pressing the switch "
board motor up, then tilts it up. Pressing the
" (off) posi-
switch "
down and trims it down. When the switch is re-
leased, the outboard motor will stop in its cur-
rent position.
" (on) position,
NOTE:
For instructions on using the power trim and
tilt switch, see pages 34 and 36.
Basic components
" (on) position.
" (up) trims the out-
" (down) tilts the outboard motor
" (start) po-
16
Advertisement
Table of Contents
