Cisco ASR 5000 Administration Manual page 51
Enhanced wireless access gateway
Hide thumbs
Also See for ASR 5000:
- Administration manual (466 pages) ,
- Installation manual (294 pages) ,
- Installation procedure (8 pages)
Table of Contents
Advertisement
RADIUS-based Enhanced Wireless Access Gateway Configuration
<aaa_server_group_name> ] [ clear-sessions ] + ] [ dictionary <dictionary_name> ] [
disconnect-message [ dest-port <destination_port_number> ] + | interim create-new-call }
#To enable mapping of UE MAC address to IMEIsV IE of GTP message in order to send it to
the GGSN:
map ue-mac-to-imei
#To configure timeout for R-eWAG session setup attempts:
setup-timeout <setup_timeout>
end
Notes:
In the APN profile configuration,
service. It should be configured as NI+OI for proper DNS resolution. Also, note that R-eWAG does not
support subscriber profile.
<dictionary_name>
which dictionary to use in your deployment, contact your Cisco account representative. The default dictionary
is
starent-vsa1
In the RADIUS accounting parameter configurations, the
RADIUS accounting messages to the configured RADIUS accounting client if the call goes down due to any
failure. If this option is not configured, the R-eWAG will not send Disconnect-Message in call failure
scenarios.
In the binding configuration, the
accounting requests are received. This keyword should be configured if the source of the RADIUS requests is
in a different context than the R-eWAG service. If not configured, the system will default to the context in
which the R-eWAG service is configured.
The
map ue-mac-to-imei
enabled, the UE MAC received in "Calling-Station-Id" RADIUS attribute is mapped to IMEIsV and sent in
GTP CPC message towards the GGSN.
Configuring R-eWAG + GGSN Combo Deployment
To configure the R-eWAG service for an R-eWAG + GGSN combo deployment use the following configuration:
configure
context <context_name>
ipsg-service <ipsg_service_name> mode radius-server ewag
#To associate an SGTP service:
associate sgtp-service <sgtp_service_name> [ context <sgtp_context_name> ]
#To bind the R-eWAG service to a logical AAA interface and configure the number of
subscriber sessions allowed:
bind address <ipv4/ipv6_address> [ max-subscribers <max_sessions> | port
<port_number> | source-context <source_context> ]
<default_apn_name>
specifies the RADIUS dictionary to use for the R-eWAG service. For information on
.
source-context
CLI command supports enabling/disabling UE MAC to IMEI mapping. When
Cisco ASR 5000 Enhanced Wireless Access Gateway Administration Guide ▄
specifies the default APN to be used for the R-eWAG
disconnect-message
option specifies the source context where RADIUS
R-eWAG Configuration ▀
option enables sending
51
Advertisement
Table of Contents
