Table of Contents
Advertisement
Chapter 2
Installing the Cisco IPVC 3500 Series Gateway
Slide the RTM halfway into the chassis.
Step 9
Attach the 16-pin flat cable to connector JP2 on the RTM module (see
Step 10
Figure 2-3
Slide the PRI RTM into the chassis until it stops.
Step 11
Use even pressure to push the module further into the slot.
Step 12
Warning
Step 13
Snap the latch handles forward to secure the module in the slot.
Secure the PRI RTM screws.
Installing the PRI RTM in a Cisco IPVC 3544 Chassis Slot Other Than the Top
Slot
To install the PRI RTM in chassis slot two, three, or four, perform the following steps.
If the power to the chassis is on, you must install the RTM before you install the
Warning
Cisco IPVC 3540 PRI Gateway module.
Procedure
On the back of the chassis, loosen the screws that secure the latches of the top cover panel.
Step 1
Press the red release button and snap the black handles back to open the latches.
Step 2
Step 3
Remove the cover plate.
Remove the PRI RTM from the antistatic bag.
Step 4
Align the edges of the PRI RTM with the chassis guide rails.
Step 5
Slide the RTM into the chassis until it stops.
Step 6
Use even pressure to push the module further into the slot.
Step 7
Administrator's Guide for Cisco IPVC 3521 BRI Gateway, Cisco IPVC 3526 PRI Gateway, and Cisco IPVC 3540 PRI Gateway
OL-7995-01
Connecting the 16-pin Flat Cable to the RTM
Do not force the connection. Forcing the connection can bend or damage the pins in the
connector inside the chassis.
Installing the Cisco IPVC 3540 PRI Gateway
US B 2
Figure
2-3).
2-7
- Quick Links:
- Table of Contents
- Objectives
Hide quick links:
Advertisement
Table of Contents
