Table of Contents
Advertisement
Connecting Power
Connecting AC Power to the Power Supply
Equipment
•
The device is designed to work with TN power systems. Statement 19.
Warning
Step 1
Ensure that the power switch on the power supply is in the OFF (0) position.
Slide the cable-retention clip to the left, away from the AC receptacle, and plug in the power cable.
Step 2
Secure the cable in the power supply AC receptacle by sliding the cable-retention clip to the right until
Step 3
it fits around the connector. The cable-retention clip provides strain relief for the AC power cable. (See
Figure
Note
Plug the AC power supply cable into the AC power source.
Step 4
This completes the procedure for connecting AC-input power.
Note
Wait until the system has been cabled before turning on the power supply. See the
Switch" section on page 5-26
Figure 3-8
Cisco uBR-3x10 RF Switch Hardware Installation and Cabling Guide
3-16
AC power cord
3-8.)
For additional AC power cable strain relief, secure the cable to the power supply handle by
inserting a nylon cable tie through the hole in the handle and around the cable.
Connecting AC Power
Chapter 3
Installing the Cisco RF Switch
"Powering On the RF
OL-1984-06
Advertisement
Chapters
Table of Contents
