Table of Contents
Advertisement
Rack-Mounting the RF Switch with the Cisco uBR10012 CMTS
Attaching the Brackets for the Cisco uBR10012 CMTS
This section explains how to attach the rack-mount brackets to a Cisco uBR 3x10 RF Switch for
flush-front installations as shown in
We recommend that you install the rack-mount brackets on the front portion of the Cisco uBR 3x10
Tip
RF Switch so that the MCX connector side of the RF switch (coinciding with the RF cable interfaces on
the cards in the Cisco uBR10012 router) face the rear of the rack.
Equipment
•
•
•
To install the rack-mount brackets for a flush-front configuration, complete the following steps:
Step 1
Locate the threaded holes in the front sides of the chassis.
Figure 3-3
Rack-mount
bracket
Align the first rack-mount bracket with the threaded holes in the front right side of the chassis. Align the
Step 2
bracket with the chassis as shown in
Cisco uBR-3x10 RF Switch Hardware Installation and Cabling Guide
3-6
Two brackets (Cisco part number 74-2620-01)
Four M5 x 8-mm Phillips countersunk screws
Number 2 Phillips screwdriver
Installing the Rack-Mount Brackets on the Cisco uBR 3x10 RF Switch (Front Mount)
Front
Figure 3-1
and
Figure
3-2.
Figure 3-3 on page
3-6.
Chapter 3
Installing the Cisco RF Switch
Rack-mount
bracket
Rear
OL-1984-06
Advertisement
Chapters
Table of Contents
