Installation Checklist - Cisco uBR-3x10 Hardware Installation And Cabling Manual

Rf switch

Table of Contents

Installing the Cisco RF Switch

This chapter explains the procedures to install and connect the Cisco uBR 3x10 RF Switch. The chapter

contains the following sections:

•

Installation Checklist

A rack-mount kit is included in the shipping container. The rack-mount brackets in the kit are for

mounting the Cisco uBR 3x10 RF Switch in a standard, 19-in.-wide, 4-post equipment rack.

The rack-mount brackets are not suitable for use with other racks, such as 23-in. telco racks.

Note

If you are installing an equipment shelf or using mounting hardware other than that supplied with the

chassis, review the guidelines in the

If you do not plan to install your Cisco uBR 3x10 RF Switch in an equipment rack, proceed to the

"Installing the Cisco uBR 3x10 RF Switch on a Workbench or Tabletop Environment" section on

page

To assist you with your installation and provide a historical record of what was done, and by whom, use

the Installation Checklist in

procedure or verification is completed.

OL-1984-06

3-13.

Table 3-1 on page

C H A P T E R

"Equipment Racks" section on page

3-2. Print a copy of this checklist and indicate when each

Cisco uBR-3x10 RF Switch Hardware Installation and Cabling Guide

2-8.

3-1

Table of Contents

Table of Contents