Table of Contents
Advertisement
Connecting the RF Cables (MC16x, MC28C Line Cards)
Figure 4-12
16
15
Table 4-4
Cisco uBR10-LCP2-MC28C Cabling (DS Ports to the Upconverter)
Color
Line Card Slot
Brown
8/0—working
Gray
8/0—working
Brown
8/1—working
Gray
8/1—working
Brown
7/0—working
Gray
7/0—working
Brown
7/1—working
Gray
7/1—working
Cabling the Output Ports from the Upconverter to the RF Switch
This section describes cabling from the output ports on the upconverter to the RF switch.
Equipment
•
•
To cable the output ports on the upconverter to the RF switch, complete the following steps.
Connect the cable to the output connector (1–lower) on the upconverter.
Step 1
Connect the cable to the appropriate MCX connection on the CABLE PLANT header block.
Step 2
•
•
Repeat
Step 3
Cisco uBR-3x10 RF Switch Hardware Installation and Cabling Guide
4-18
Chapter 4
Cabling the Input Ports on the Upconverter (MC28C)
14
13
12
11
10
9
DS Port
UPx Conn
DS1
16
DS0
15
DS1
14
DS0
13
DS1
12
DS0
11
DS1
10
DS0
9
8 cables for Cisco uBR10-LCP2-MC16x cards (F-connector to MCX connector–gray)
16 cables for Cisco uBR10-LCP2-MC28C cards (F-connector to MCX connector–gray, brown)
For Cisco uBR10-LCP2-MC16x cards, see
For Cisco uBR10-LCP2-MC28C cards, see
Step 1
through
Step 2
for the remaining cables
Cabling the RF Switch With the Cisco uBR10012 CMTS Cable Interface Line Cards
8
7
6
5
4
3
2
1
Color
Line Card Slot
Brown
6/0—working
Gray
6/0—working
Brown
6/1—working
Gray
6/1—working
Brown
5/0—working
Gray
5/0—working
Brown
5/1—protect
Gray
5/1—protect
Table 4-5 on page
Table 4-6 on page
Input
DS Port
UPx Conn
DS1
8
DS0
7
DS1
6
DS0
5
DS1
4
DS0
3
DS1
2
DS0
1
4-19.
4-19.
OL-1984-06
Advertisement
Chapters
Table of Contents
