Table of Contents
Advertisement
Scope
Tip
Statement numbers (Statement 1030) at the end of a warning refer to specific warnings and their
translations found in the Regulatory Compliance and Safety Information for the Cisco RF Switch.
Scope
The guide provides installation and cabling information for the Cisco uBR 3x10 RF Switch. Refer to the
"Related Documentation" section on page 10 for related Cisco publications that provide configuration
information for the Cisco uBR 3x10 RF Switch.
Document Organization
This hardware installation guide is organized into the following chapters and appendixes:
Chapter Title
Chapter 1, "Cisco uBR-3x10 RF
Switch Overview"
Chapter 2, "Preparing for
Installation"
Chapter 3, "Installing the
Cisco RF Switch"
Chapter 4, "Cabling the RF Switch
With the Cisco uBR10012 CMTS
Cable Interface Line Cards"
Chapter 6, "Troubleshooting"
Appendix A, "Specifications and
Component Part Numbers"
Document Conventions
This guide uses the following conventions:
Means reader take note. Notes contain helpful suggestions or references to materials not contained in
Note
this manual.
Means reader be careful. You are capable of doing something that might result in equipment damage or
Caution
loss of data.
Cisco uBR-3x10 RF Switch Hardware Installation and Cabling Guide
4
Description
Describes the Cisco uBR 3x10 RF Switch chassis and
components, illustrating the supported system configurations.
Describes safety considerations, tools, and other equipment
required to prepare your site.
Provides instructions to install and connect cables to the chassis.
Provides instructions for connecting Cisco uBR 3x10 RF Switch
cable network redundancy cables in a Cisco uBR10012 CMTS
environment.
Provides basic Cisco uBR 3x10 RF Switch troubleshooting
information.
Provides Cisco uBR 3x10 RF Switch system specifications.
Preface
OL-1984-06
Advertisement
Chapters
Table of Contents
