Table of Contents
Advertisement
C. Network environment (Network card installation)
1) Insert the network card into the network card slot on the printer
control PWB. and fix it with screws.
2) Install the printer control PWB to the copier.
3) Connect the network cable to the network card connector.
4. Setup on the copier side
A. Setup by simulation
Setup the following items. For parallel I/F, setup, if there is no trouble
in operations, there is no need to change any settings.
Content
System configuration setup
Print counter count mode setup
Parallel I/F timing adjustment
Parallel I/F select IN signal timing
B. Setup by key operator program
Refer to the section of the key operator program and make setting
according to the user environment.
5. Software installation and setup
Checking the Hardware and Software Requirements
You will need the following hardware and software in order to install
the printer driver.
(Windows)
•
Computer Type
IBM PC/AT or compatible computer
equipped with a bi-directional parallel
interface
•
Operating System
Windows 3.1x, Windows 95, Windows 98,
Windows 2000, Windows NT 4.0
•
CPU
Windows 3.1/Windows 95: 486SX or better
•
Windows 98: 486DX/66 MHz or better
(Pentium or better is recommended.)
•
Windows NT4.0: 486/25MHz or better
•
RAM
Windows 3.1/Windows 95: 8 MB or more
(12 MB or more is recommended.)
•
Windows 98/Windows 2000: 16 MB or more
(32 MB or more is recommended.)
•
Windows NT 4.0: 16 MB or more
(Macintosh)
•
Operating system
Mac OS 7.6 to 9.0
•
CPU
MC 68040 or PowerPC microprocessor
•
RAM
16 MB or more for PowerPC microprocessor
machine
•
12 MB or more for MC 68040 machine
•
Printer driver
LaserWriter 8 version 8.4.1 or later
To use the printer with a Macintosh computer, an optional network
interface card (Print Server Card) is needed. Also the Macintosh com-
puter must be equipped with an Ethernet port. If your computer is not
equipped with an Ethernet port, install an Ethernet interface.
6. Setup under network environment
Check the user environment and make setup according to the Opera-
tion Manual attached to the network card.
A. Outline of the NW Setup
The NW Setup is a setup tool for using a SHARP printer with a
network card installed in a Novell NetWare environment. Registration
of printers to a NetWare server and parameter settings for a network
card can be performed by using a procedure with wizards.
For using the NW Setup, a Novell Client supplied by Novell must
have been installed. Also before starting the NW Setup, you must log
in the NetWare server with the 'Administrator' privileges.
3 – 4
AR-PB2A
Simulation No.
Set value
26-44
1
26-05
67-03
67-11
Advertisement
Table of Contents
