Care must be taken to ensure that the appliance does not stand on the electrical supply cable or on the water inlet and drain hoses. Zanussi dishwashers are designed to be used for washing normal household utensils. Items that are contaminated by petrol, paint, steel or iron debris, corrosive, acidic or alkaline chemicals are not to be washed in a dishwasher.
INSTALLATION Remove all packaging before positioning the The water supply hose is fitted with a safety device, machine. which prevents water from entering the machine should the inner hose split, due to wear. Positioning The problem is signalled by a red or yellow indicator which appears in window (B - If possible, position the machine next to a water tap and a drain.
Control panel PROGRAMME DELAY ECONOMY SELECTOR START CANCEL THE CONTROLS 1. ON/OFF In this fully integrated appliance the controls are located on top of the door. When selecting a programme, the Press this button to preset the dishwasher to accept door needs to be partially opened.
Page 6
5. Economy dry button 7. Cancel / programme change button When this button is pressed, the last rinse water is not If you wish to cancel a programme which is already heated, with a significant saving in electrical energy. running or a setting which has just been made, press The corresponding pilot light comes on.
Page 7
Rinse aid Use of detergent The use of this liquid ensures thorough rinsing, spot Before starting any of the dishwashing programmes, and streak free drying, making the water run quickly except for the Rinse and Hold programme, load the off the dishes for sparkling results. It is automatically detergent in the dispenser.
Page 8
Loading your machine The two rear rows of prongs on the lower basket can be easily lowered to allow you to load pots, pans and Before placing dishes in the machine, remove any bowls. scraps of food from the plates (small bones, To lower the prongs: toothpicks, fish bones, scraps of meat and vegetables, slightly pull them upward...
Adjusting the height of the upper basket Move the front runner stops (A) of the upper basket outward and slide the basket out. If washing very large plates (over 27 cm and up to 31 Refit the basket in the higher position and replace the cm in diameter) you can load them in the lower basket stops (A) in their original position.
WASHING PROGRAMMES Recommended quantity of detergent Cycle Degree of soil and Recommended Pro- Required Description in the in the type of load gramme programme Pushbuttons Super Intensity dispenser Dispenser Any. RINSE 1 cold rinse (to avoid Programme Partial load (to be food scraps from Selector completed later in the...
Operating Sequence 7. Starting the wash programme Open the water tap. 1. Check that the filters are clean Close the dishwasher door. (see cleaning instructions) An audible signal lasting about 1 second informs you that the programme has been started. 2.
MAINTENANCE AND CLEANING Cleaning the central filters Internal and external cleaning (After each wash) You must ensure that the seals around the door, the detergent and rinse aid dispensers are cleaned Inspect the central filters (B) and (C) and remove any regularly with a damp cloth.
Prolonged Periods of Non-Operation If you are not using the machine for any period of time you are advised to: unplug the appliance and turn off the water; fill the rinse aid dispenser; leave the door ajar to prevent the formation of unpleasant smells;...
SERVICING Certain problems are due to lack of simple maintenance or oversights and can be solved easily without having to call out an engineer. Therefore before calling the Service, consult the check list here below. The following alarms, in the form of letters (A, C, F, L, H, P) flash in the digital display window. The dishwasher fails to start or stops during operation;...
Page 15
Visible lime deposits or white film on the Protection against flooding dishes In order to prevent water floods, the dishwasher has been provided with two additional devices, having the The rinse aid has run out or too little is being used. following characteristics: 1.
BUILDING-IN Mounting of decor panel onto the door Building-in features The height of the panel depends on the height of the This dishwasher is designed to be fitted under a kitchen plinth of adjacent kitchen units (see kitchen plinth counter or sink. adjustment).
Page 17
Securing under a counter Levelling Secure the dishwasher to Make sure that the dishwasher door closes properly, the counter on the front without rubbing on sides. Otherwise level the machine part by means of two by slightly screwing or unscrewing the two front feet 4,2x13 screws provided until perfect closure of the door is reached.