Table of Contents
Advertisement
Installing the CPE
Figure 2-3
Installing the Mounting Screws Under a Desk
Desktop
Screw template
Screw
Step 4
Step 5
Step 6
Step 7
Step 8
Step 9
Cisco LRE CPE Hardware Installation Guide
2-16
Screw
Note
The template has adhesive to hold it in place while you drill holes
underneath the desktop. If you have purchased a 6- or 24-multipack, you
will be using the same screw template to install several CPEs. Do not use
the adhesive. Instead, hold the template against the bottom of the desk
while you drill the screw holes and insert the screws.
(Optional) Peel the adhesive strip off the bottom of the screw template, and attach
it to the underside of the desk.
Use a 0.144-inch (3.7-millimeters) or a #27 drill bit to drill 1/2-inch
(12.7-millimeters) holes in the two screw template slots.
(Optional) If you wish to attach the cable lock after the cables are installed, drill
a 1/2-inch (12.7-millimeters) hole in the cable lock hole. For more information,
see the
"Attaching the Cable Lock" section on page
Insert two screws in the slots on the screw template, and tighten until they touch
the top of the screw template.
Remove the screw template from underneath the desk.
Slide the CPE onto the mounting screws until it locks in place. (See
Cable
lock hole
Adhesive
2-29.
Chapter 2
Installation
Wall
at least
1/2 in.
(12.7 mm)
3 in.
(7.6 cm)
Figure
2-4.)
78-11469-04
Advertisement
Chapters
Table of Contents
Troubleshooting
