Table of Contents
Advertisement
Chapter 2
Installation
Note
Installing the CPE
Installing the CPE on a Desk (without Mounting Screws)
Step 1
Step 2
Step 3
78-11469-04
•
One RJ-45-to-RJ-45, straight-through Ethernet cable (Cisco 575 LRE CPE
and Cisco 576 LRE 997 CPE only)
•
Product ownership registration card
The CPE is sold individually or in multipackages of 6 and 24. The multipackages
include only one hardware installation guide, one screw template, and one product
ownership registration card for every six CPE devices.
You can install the CPE on or under a desk or on a wall. Before you begin the
installation, decide where to mount the CPE by reviewing the illustrations in these
sections:
•
Installing the CPE on a Desk (without Mounting Screws), page 2-11
Installing the CPE on a Desk (with Mounting Screws), page 2-12
•
Installing the CPE Under a Desk, page 2-15
•
Installing the CPE on a Wall, page 2-18
•
The CPE can be installed on top of a desk with mounting screws or just placed on
the desk. If you do not wish to install the CPE with mounting screws, follow these
steps:
Locate the adhesive strip with the rubber feet in the CPE mounting kit.
Remove the four rubber feet from the adhesive strip, and attach them to the
recessed areas on the bottom of the unit. This prevents the CPE from sliding on
the desktop.
Place the CPE on the desktop.
Cisco LRE CPE Hardware Installation Guide
Installing the CPE
2-11
Advertisement
Chapters
Table of Contents
Troubleshooting
