Configure Network Settings - Cisco 8941 Administration Manual
Ip phone, unified communications manager 10.0 (sccp and sip)
Hide thumbs
Also See for 8941:
- User manual (120 pages) ,
- Reference manual (28 pages) ,
- Release notes (16 pages)
Table of Contents
Advertisement
Configure Network Settings
• To enter a period (for example, in an IP address), press star (*) on the keypad.
• Press the up arrow on the Navigation bar to move the cursor to the left most character, and press the
• Press
• Press Cancel before pressing Save to discard any changes that you have made.
The Cisco Unified IP Phone provides several methods you can use to reset or restore option settings, if
Note
necessary.
Configure Network Settings
The Network Setup menu provides options to view and make a variety of network settings. The following
table describes these options and, where applicable, explains how to change them.
Table 1: Network Setup Menu Options
Option
IPv4 Setup
Host Name
Domain Name
Operational VLAN ID
Cisco Unified IP Phone 8941 and 8945 Administration Guide for Cisco Unified Communications Manager 10.0
(SCCP and SIP)
6
down arrow on the Navigation bar to move the cursor to the right most character.
if you make a mistake. This softkey deletes the character to the left of the cursor.
Description
In the IPv4 Setup submenu, you can do the
following:
• Enable or disable the phone to use the
IP address that is assign by the DHCP
server.
• Manually set the IP Address, Subnet
Mask, Default Routers, DNS Server,
and Alternate TFTP servers.
Unique host name that the DHCP server
assigned to the phone.
Name of the Domain Name System (DNS)
domain in which the phone resides.
Auxiliary Virtual Local Area Network
(VLAN) configured on a Cisco Catalyst
switch in which the phone is a member.
If the phone has not received an auxiliary
VLAN, this option indicates the
Administrative VLAN.
If neither the auxiliary VLAN nor the
Administrative VLAN are configured, this
option defaults to a VLAN ID of 4095.
Cisco Unified IP Phone Installation
To change
Set Up IPv4, on page 9
Display only—Cannot configure.
Set Domain Name Field, on page 10
Display only—Cannot configure.
The phone obtains its Operational
VLAN ID using Cisco Discovery
Protocol (CDP) from the switch to
which the phone is attached. To
assign a VLAN ID manually, use the
Admin VLAN ID option.
Hide quick links:
Advertisement
Table of Contents
