Table of Contents
Advertisement
Configuration Examples for Configuring Workgroup Bridges
Command or Action
Step 8
debug dot11 state
Example:
Switch# debug dot11 state
Configuration Examples for Configuring Workgroup Bridges
WGB Configuration: Example
This example shows how to configure a WGB access point using static WEP with a 40-bit WEP key:
Switch# configure terminal
Enter configuration commands, one per line.
Switch(config)# dot11 ssid WGB_with_static_WEP
Switch(config-ssid)# authentication open
Switch(config-ssid)# guest-mode
Switch(config-ssid)# exit
Switch(config)# interface
Switch(config)# station-role workgroup-bridge
Switch(config-if)# encry mode wep 40
Switch(config-if)# encry key 1 size 40 0 1234567890
Switch(config-if)# ssid WGB_with_static_WEP
Switch(config-if)# end
Verify that the WGB is associated to an access point by entering this command on the WGB:
show dot11 association
Information similar to the following appears:
Switch# show dot11 associations
802.11 Client Stations on Dot11Radio0:
SSID [FCVTESTING] :
MAC Address
000b.8581.6aee 10.11.12.1
ap#
Lightweight Access Point Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
68
dot11Radio 0
IP address
Device
WGB-client
Using Cisco Workgroup Bridges
Purpose
Enables dot11/state debugging. Debug an IP assignment
issue when static IP is used.
End with CNTL/Z.
Name
Parent
map1
-
State
Assoc
OL-28697-01
Advertisement
Table of Contents
