Configuring Retransmission Interval And Retry Count; Finding Feature Information; Prerequisites For Configuring The Access Point Retransmission Interval And Retry Count; Information About Retransmission Interval And Retry Count - Cisco IOS XE Release 3SE Configuration Manual
Lightweight access point configuration guide, cisco ios xe release 3se (catalyst 3650 switches)
Table of Contents
Advertisement
Configuring Retransmission Interval and Retry
Count
•
•
•
•
•
•
•
Finding Feature Information
Prerequisites for Configuring the Access Point Retransmission
Interval and Retry Count
• You can configure the retransmission intervals and retry count both at a global and a specific access
Information About Retransmission Interval and Retry Count
The switch and the access points exchange packets using the Control and Provisioning of Wireless Access
Points (CAPWAP) reliable transport protocol. For each request, a response is defined. This response is used
OL-28697-01
Finding Feature Information, page 31
Prerequisites for Configuring the Access Point Retransmission Interval and Retry Count, page 31
Information About Retransmission Interval and Retry Count, page 31
How to Configure Access Point Retransmission Interval and Retry Count, page 32
Viewing CAPWAP Maximum Transmission Unit Information (CLI), page 34
Viewing CAPWAP Maximum Transmission Unit Information (GUI), page 34
Configuration Examples for Configuring Access Point Retransmission Interval and Retry Count, page
35
point level. A global configuration applies these configuration parameters to all the access points.
Alternatively, when you configure the retransmission level and retry count at a specific access point
level, the values are applied to that particular access point. The access point specific configuration has
a higher precedence than the global configuration.
Lightweight Access Point Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
5
C H A P T E R
31
Advertisement
Table of Contents
