Configuring The Switch; Configuring The Switch Using The Configuration Setup Wizard; Quick Setup: Accessing The Configuration Setup Wizard - Cisco Catalyst 2960-L Smart Managed Series Hardware Installation Manual
Smart managed 24-portand 48-port switch
Hide thumbs
Also See for Catalyst 2960-L Smart Managed Series:
- Getting started manual (20 pages) ,
- Hardware installation manual (80 pages) ,
- Installation manual (22 pages)
Table of Contents
Advertisement
Configuring the Switch
This appendix contains these topics:
•
•
Configuring the Switch Using the Configuration Setup Wizard
Quick Setup: Accessing the Configuration Setup Wizard
When you first set up the switch, use the Configuration Setup wizard to enter the initial IP information. This
enables the switch to connect to local routers and the Internet. You can then access the switch through the IP
address for further configuration.
Note
The switch also supports Bluetooth which can be enabled via WebUI or using the CLI command staging
config bluetooth on. This command will enable Bluetooth and a default DHCP server pool for the Bluetooth
interface. Connect your PC to the switch using Bluetooth. In your web browser, enter the IP address 172.16.0.1.
The default Bluetooth pin is '9999'. Enter the following default credentials: username: smartm, password:
c2960lsm and press Enter.
Configuring the Switch Using the Configuration Setup Wizard, on page 51
Configuring the Switch Using the CLI, on page 53
Cisco Catalyst 2960-L Smart Managed Series 24-Port and 48-Port Switch Hardware Installation Guide
C
A P P E N D I X
51
Advertisement
Table of Contents
