Cisco 8941 Release Notes page 10
Unified ip phone, firmware release 9.3(2)sr1
Hide thumbs
Also See for 8941:
- User manual (120 pages) ,
- Reference manual (28 pages) ,
- Administration manual (16 pages)
Table of Contents
Advertisement
Open caveats
For more information about an individual defect, you can access the online record for the defect by clicking
the Identifier or going to the URL that is shown. You must be a registered Cisco.com user to access this online
information.
Because defect status continually changes, the table reflects a snapshot of the defects that were open at the
time this report was compiled. For an updated view of open defects, access Bug Toolkit as described in
Cisco Software Bug Toolkit, on page
Table 1: Open Caveats for Firmware Release 9.3(2)SR1
Identifier
CSCtj58630
CSCty66252
CSCtz33988
CSCub47606
CSCub49641
CSCub49650
CSCub71691
CSCub73847
CSCub95739
CSCuc10527
CSCuc18395
CSCuc32978
CSCuc32986
CSCuc56788
CSCuc57206
CSCuc64784
CSCuc67771
CSCuc75147
CSCuc75205
CSCud07892
Cisco Unified IP Phone 8941 and 8945 Release Notes for Firmware Release 9.3(2)SR1
6
Cisco Unified IP Phone 8941 8945 Release Notes for Firmware Release 9.3(2)SR1
5.
Headline
8945 SCCP: Phone Scroll time between active calls is 180ms
8945 SIP:Video window displays incorrect after swap with MCU video conf
8945 SIP:PIP window shouldn't jump to w360 rem video window from interop
8945 SIP: Video resume time is 1248ms over vpn(encrypted)
8945 SCCP: Scroll time between active calls is 248ms over vpn(encrypted)
8945 SCCP: Scroll time between active calls is 230ms over vpn(non secu)
8945 SCCP:Sometimes lip-sync<-30 VGA and CIF@15fps RTCP_disabled
8945 SIP:lip-sync<-30@VGA_15fps_RTCP_disabled and RTCP_Enabled
SCCP: Can't exit new call page by eixt sk after cancel call from PD
8945 SIP: Not try alternate tftp svr to get wallpaper if no cfg files
8945 SIP:Resume response time is about 1240ms for encrypted phone
8945 SIP:Prompt message isn't correct after press Cancel of EM
8945 SIP:Havn't return to App menu after press exit of EM
8945 SCCP:Can't register ok after factory reset in sEMCC login state
8945 SCCP:Shouldn't return to EM login ui after one call end
Alerting Name is not displayed in placed call history in 894x phones
8945 SIP: The text size of "+" indicator for MWI number is too small
8945 SCCP:Don't set CFW using call log filter when failover to srst
8945 SCCP:Call history is chaos when Phone failover to srst
894x: Placed calls shows alerting number instead of actual dialed digits
Access
Advertisement
Table of Contents
