Monitor Protocol; Monitor Subscriber - Cisco ASR 5000 Administration Manual

Enhanced wireless access gateway

Hide thumbs Also See for ASR 5000:

Table of Contents

▀ eWAG Administration

Monitor Protocol

The system's protocol monitor displays information for every session that is currently being processed. Depending on

the number of protocols monitored, and the number of sessions in progress, a significant amount of data is generated. It

is highly recommended that logging be enabled on your terminal client in order to capture all of the information that is

generated.

To view monitor protocol based logging information, in the Exec Mode use the following command:

monitor protocol

For eWAG use the following filters:

 41 - IPSG RADIUS Signal: Must be used to view the RADIUS accounting messages on the control path for

IPSG session management.

 24 - GTPC

 26 - GTPU

The system's protocol monitor can be used to display information for a specific subscriber session that is currently

being processed. Depending on the number of protocols monitored, and the number of sessions in progress, a significant

amount of data is generated. It is highly recommended that logging be enabled on your terminal client in order to

capture all of the information that is generated.

To view monitor subscriber based logging information, in the Exec Mode use the following command:

monitor subscriber

The following filters are available for monitor subscriber based logging in eWAG.

 By MSID/IMSI

 By IP Address

 By MSISDN

 Next-IPSG Call

 By Username

▄ Cisco ASR 5000 Enhanced Wireless Access Gateway Administration Guide

Enhanced Wireless Access Gateway Configuration

OL-28188-02

Table of Contents