Table of Contents
Advertisement
Enter the following login information:
Step 2
• Username: admin
• Password: ironport
The hostname parameter is assigned during system
Note
setup. Before you can connect to the management
interface using a hostname (http://hostname:8080), you
must add the appliance hostname and IP address to
your DNS server database.
Click Login.
Step 3
Command-Line Interface
For command-line interface access via the serial port
Step 1
(see the
access the command-line interface by SSH or a terminal
emulator using 9600 bits, 8 bits, no parity, 1 stop bit
(9600, 8, N, 1) and flow control set to Hardware.
Initiate a session to the IP address 192.168.42.42.
Step 2
Log in as admin with the password ironport.
Step 3
At the prompt, run the systemsetup command.
Step 4
14
"Connect to the Appliance" section on page
12),
Advertisement
Table of Contents
