Table of Contents
Advertisement
8
Connect to the Appliance
Plug the Ethernet cables into the appropriate ports on the back
panel of the Cisco S170 appliance.
• The proxy ports are labeled P1 and P2.
P1 only enabled: When only P1 is enabled, connect it to
–
the network for both incoming and outgoing traffic.
P1 and P2 enabled: When both P1 and P2 are enabled,
–
you must connect P1 to the internal network and P2 to
the Internet.
• The traffic monitor ports are labeled T1 and T2.
Simplex tap: Ports T1 and T2; one cable for all packets
–
destined for the Internet (T1) and one cable for all
packets coming from the Internet (T2).
Duplex tap: Port T1; one cable for all incoming and
–
outgoing traffic.
Management PC
12
MGMT
CONSOLE
P1
L4 Switch/
WCCP Router
P2
T1
T2
Ethernet TAP
Simplex/Duplex
Advertisement
Table of Contents
