Cisco MDS 9216 Hardware Installation Manual page 76
Hide thumbs
Also See for MDS 9216:
- Configuration manual (96 pages) ,
- Hardware installation manual (36 pages) ,
- Connection manual (13 pages)
Table of Contents
Advertisement
Removing and Installing Components
Send documentation comments to mdsfeedback-doc@cisco.com.
To install a module in slot 2 of the chassis, follow these steps:
Verify that there is enough clearance to accommodate any interface equipment
Step 1
that you connect directly to the nearby components.
If a filler panel is installed, remove the two Phillips pan-head screws from the
Step 2
filler panel and remove the panel. To remove a currently installed module, see the
"Removing and Installing Switching and Services Modules" section on
page
Step 3
Open fully both ejector levers on the new or replacement module (see
on page
Position the module in the chassis as follows:
Step 4
a.
b.
c.
Figure 2-11 Closing the Ejector Levers
Do not press down too forcefully on the levers because they can bend.
Caution
Cisco MDS 9216 Switch Hardware Installation Guide
2-26
2-22.
2-23).
Position the module in the slot, aligning the sides of the module carrier with
the slot guides on each side of the slot.
Slide the module carefully into the slot until the EMI gasket along the top
edge of the module makes contact with the supervisor module above it and
both ejector levers have closed to approximately 45 degrees with respect to
the module faceplate (see
Grasp the two ejector levers using the thumb and forefinger of each hand and
press down to create a small 0.040 inch (1 mm) gap between the module's
EMI gasket and the module above it (see
MDS 9216
1
1
2
3
4
FAN
STATUS
2
1
2
3
4
FAN-MOD-2
Ejector levers flush with
Chapter 2
Installing the Cisco MDS 9216 Switch
Figure 2-10 on page
Figure
5
6
7
8
9
10
11
12
5
6
7
8
9
10
11
12
module faceplate
Figure 2-9
2-24).
2-11).
CONSOLE
MGMT 10/100
COM1
13
14
15
16
13
14
15
16
78-16165-01
Advertisement
Table of Contents
Troubleshooting
