Starting Up The Switch - Cisco MDS 9216 Hardware Installation Manual
Hide thumbs
Also See for MDS 9216:
- Configuration manual (96 pages) ,
- Hardware installation manual (36 pages) ,
- Connection manual (13 pages)
Table of Contents
Advertisement
Chapter 2
Installing the Cisco MDS 9216 Switch
Send documentation comments to mdsfeedback-doc@cisco.com.
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Starting Up the Switch
Warning
Caution
78-16165-01
To attach the grounding lug and cable to the chassis, follow these steps:
Use a wire-stripping tool to remove approximately 0.75 inch (19 mm) of the
covering from the end of the grounding cable.
Insert the stripped end of the grounding cable into the open end of the grounding
lug.
Use the crimping tool to secure the grounding cable in the grounding lug.
Remove the adhesive label from the grounding pad on the chassis.
Place the grounding lug against the grounding pad so that there is solid
metal-to-metal contact, and insert the two M4 screws with washers through the
holes in the grounding lug and into the grounding pad. Ensure that the lug and
cable do not interfere with other equipment.
Prepare the other end of the grounding cable and connect it to an appropriate
grounding point in your site to ensure adequate earth ground.
This section provides the following information:
Connecting the Power Supplies, page 2-18
•
Powering Up the Switch and Verifying Component Installation, page 2-19
•
Hazardous voltage or energy is present on the backplane when the system is
operating. Use caution when servicing. Statement 1034
During this procedure, wear grounding wrist straps to avoid ESD damage to the
switch.
Cisco MDS 9216 Switch Hardware Installation Guide
Starting Up the Switch
2-17
Advertisement
Table of Contents
Troubleshooting
