Table of Contents
Advertisement
Chapter 4
Configuring the 6T3 Line Card
Choose the subsection appropriate for your system. Proceed to the
Network Connectivity" section on page 4-15
Using the show version or show hardware Commands
Display the configuration of the system hardware, the number of each interface type installed, the Cisco
IOS software version, the names and sources of configuration files, and the boot images by using the
show version (or show hardware) command.
The outputs that appear in this document may not match the output you receive when running these
Note
commands. The outputs in this document are examples only.
Cisco 7304 Routers
Following is an example of the show version command from a Cisco 7304 router with the 6T3 line card:
Router# show version
Cisco Internetwork Operating System Software
IOS (tm) 7300 Software (C7300-JS-M), Version 12.1(1.23.139), CISCO DEVELOPMENT VERSION
Copyright (c) 1986-2001 by cisco Systems, Inc.
Compiled Thu 20-Dec-01 03:25 by cva
Image text-base:0x40008970, data-base:0x41796000
ROM:System Bootstrap, Version 12.1(20011026:021245) [hih-rommon_1_1 101], DEVELOPMENT
SOFTWARE
Currently running ROMMON from ROM 1
BOOTLDR:7300 Software (C7300-BOOT-M), Version 12.1(1.23.87), CISCO DEVELOPMENT VERSION
nag-ws1 uptime is 10 minutes
System returned to ROM by reload
System image file is "disk0:c7300-js-mz.121-10.EX"
cisco 7300 (NSE100) processor (revision A) with 114688K/16384K bytes of memory.
Processor board ID
R7000 CPU at 350Mhz, Implementation 39, Rev 3.2, 256KB L2, 1024KB L3 Cache
4 slot midplane, Version 65.48
Last reset from software reset or reload
Bridging software.
X.25 software, Version 3.0.0.
SuperLAT software (copyright 1990 by Meridian Technology Corp).
TN3270 Emulation software.
PXF processor tmc0 running 'system:pxf/ucode1' v1.4 is active
PXF processor tmc1 running 'system:pxf/ucode1' v1.4 is active
1 FastEthernet/IEEE 802.3 interface(s)
2 Gigabit Ethernet/IEEE 802.3 interface(s)
6 Serial network interface(s)
509K bytes of non-volatile configuration memory.
16064K bytes of ATA compact flash in bootdisk (Sector size 512 bytes).
31360K bytes of ATA compact flash in disk0 (Sector size 512 bytes).
Configuration register is 0x0
OL-3449-02
when you have finished using the show commands.
Clear Channel 6-Port T3 (DS3) Line Card Installation and Configuration
Checking the Configuration
"Using the ping Command to Verify
4-11
Advertisement
Table of Contents
