Dos Packet Driver Installation - Cisco Aironet Wireless LAN Client Installation And Configuration Manual
Wireless lan client adapters, guide for ms-dos
Hide thumbs
Also See for Cisco Aironet Wireless LAN Client:
- Installation and configuration manual (290 pages) ,
- Quick start manual (12 pages) ,
- Getting started manual (38 pages)
Table of Contents
Advertisement
DOS NDIS2 Installation
Additional variables defined in the following section can also be used. Follow these steps to install the
driver.
Power on your computer.
Step 1
Extract the NDIS.EXE files to the directory containing the network files on your computer's hard drive.
Step 2
Step 3
Copy the PROTOCOL.INI file to the network directory or merge statements from the Cisco Aironet
supplied file into your existing PROTOCOL.INI file.
Step 4
Modify the CONFIG.SYS file. After the line containing: Device = PROTMAN.DOS, add
Device = [drive:] [path] CSCNDIS2.DOS.
Step 5
To modify the PC Card system parameters, edit the PROTOCOL.INI file in the network directory. For a
list of parameters that can be modified, see
Reboot your computer.
Step 6
DOS Packet Driver Installation
The installation of this driver includes creating or editing a configuration file (CSCPKT.INI). This file
must contain the lines shown in
Table 3-3
Infrastructure Mode
[CSCPKT]
INFRASTRUCTURE = YES
If omitted, default is YES
SSID = <your SSID>
Additional variables defined in the following section can also be used.
The Wireless LAN Adapter can be installed in a MS-DOS environment by using MS-DOS IP stack
products such as FTP software.
Follow these steps to install the driver.
Step 1
Power on your computer.
Extract the PKT.EXE files to the directory containing the network files on your computer's hard drive.
Step 2
Step 3
Make sure that the CSCPKT.INI file is in the directory containing the Packet driver.
If you would like to modify the PC Card system parameters, edit the CSCPKT.INI file. For a list of
Step 4
parameters that can be modified, see Table 3.3.
Load the driver by typing CSCPKT [-cinuw] <int_number> at the MS-DOS prompt (for example,
Step 5
CSCPKT 0x65) and press Enter.
Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide for MS-DOS
3-4
Table
Minimum CSCPKT.INI Driver Settings
Table
3-2.
3-3.
Ad Hoc Mode
[CSCPKT]
INFRASTRUCTURE = NO
SSID = <your SSID>
CHANNEL = <channel>
Chapter 3
Installing the Software
OL-1744-02
Advertisement
Table of Contents
Troubleshooting
