Fixed 4X10-Gigabit Ethernet Ports - Cisco ASR 9001-S Hardware Installation Manual
Hide thumbs
Also See for ASR 9001-S:
- Hardware installation manual (160 pages) ,
- Installation manual (24 pages) ,
- Overview and reference manual (170 pages)
Table of Contents
Advertisement
Installing Modules and Cables in the Chassis
This chapter contains the procedures for installing cards and modules into the chassis, after it has been
installed in a rack. It also describes how to connect cables to the ports and RP.
The installation is presented in these sections:
•
•
•
•
•
•
•
•
•
Fixed 4x10-Gigabit Ethernet Ports
The Cisco ASR 9001 Router has four integrated 10 GE small form-factor pluggable (SFP+) ports that
operate at a rate of 10 Gbps.
Each fixed SFP+ port has an adjacent Link LED visible on the front panel. The Link LED indicates the
status of the associated SFP+ port.
In Cisco ASR 9001-S Router, two 10 GE fixed SFP+ ports (SFP+2 and SFP+3) are disabled by default,
Note
and can be enabled by a license upgrade.
Figure 3-1
OL-26701-02
Fixed 4x10-Gigabit Ethernet Ports, page 3-1
Modular Port Adapters, page 3-2
Installing and Removing Modular Port Adapters, page 3-5
Installing and Removing SFP Modules, page 3-11
Installing and Removing XFP Modules, page 3-11
Cable Management, page 3-12
Connecting Route Processor Cables, page 3-16
Connecting Power to the Router, page 3-18
Powering on the Router, page 3-21
shows the front panel of the chassis and connectors of the fixed 4x10-Gigabit Ethernet ports.
C H A P T E R
Cisco ASR 9001 and Cisco ASR 9001-S Routers Hardware Installation Guide
3
3-1
Advertisement
Table of Contents
Troubleshooting
