Table of Contents
Advertisement
INSTALLATION
1. Unpacking & Set-up of MX-85
Before removing the MX-85 from the carton, check the box for evidence of shipping
damage. If such evidence is present, notify the carrier immediately.
1.1. Unpacking
(1) Open carton.
(2) Remove accessories; ribbon, manual, etc.
(3) Grasp the MX-85 by, its underside and lift straight out with 'packing material
attached.
(4) Place the printer on a flat surface.
(5) Carefully remove packing material.
(6) Remove the vinyl cover.
1.2. Repacking
Perform in reverse order of above.
NOTE:
Be sure shipping screws and protective sheet for paper sensor are reinstalled. It is
highly recommended that all original material be retained for use in reshipment of the
MX-85.
- 2 -
Advertisement
Table of Contents
